MANO861 Mini ITX Board
10 Board and Pin Assignments
System fan interface is available through SYS_FAN1, see table below.
1
Do not forget to connect the fan cables to the fan connectors. Insufficient
air flow inside the system may damage the motherboard components.
These are not jumpers! DO NOT place jumper caps on the fan connectors.
2.4.3 COM Connectors (COM34 and COM56)
These connectors are for serial (COM) ports. Connect the serial port module cable to
this connector, then install the module to a slot opening at the back of the system
chassis.
COM34, COM56
2.4.4 GPIO Connector (JDIO)
This connector is for GPIO function.
Comments to this Manuals